You will have ten additional minutes of sleep before your alarm goes off again. If you would like, you can set a snooze by pressing the “snooze” button located on the top right corner of the clock.
Now, use the “alarm” dial to adjust the time you would like for your alarm to go off.Once you have found the alarm button, press it and hold it down until the alarm clock starts beeping.It is usually a large round button with an image of a bell on it. To set the alarm, you will need to locate the “alarm” button.This will prevent any accidental sparks from occurring while you are working inside. There is a small lever on the back of the clock that you must push down to remove the battery. Note: If your alarm clock has a battery, be sure to remove it before working on the clock. If everything is working correctly, you are done setting your alarm! Congratulations on performing this simple task with ease. If it does not, make sure that you turn both hour and minute knobs to midnight when setting the current time. Press down on the “OFF” button on the front of your alarm clock. Once you have put the clock back together, it is time to test the alarm. Consult your clock’s instruction booklet if you have any trouble with this. Be sure to replace the screws in the order they were removed, as this is how they are meant to go back together. Then replace the top of the clock and screw it in place. Make sure they are tight so the clock stays closed securely. First, replace the screws on the back panel and screw them in place.
Now that you have set your alarm clock, it is time to put everything back together. This step will also wind up your alarm system, so it is ready to sound when the time arrives. Rotate them both in a clockwise motion until they stop at midnight. Locate the “Hour” and “Minute” knobs on either side of the clock. Once your alarm is set, you are ready to set the current time. If you have trouble selecting the alarm, be sure to turn it to the right. Be sure to rotate it in a clockwise motion rotating it counter-clockwise will not work. First, locate the “Alarm” knob on the right side of the clock and rotate it to set the desired time. Now that you have exposed the interior of your Westclox alarm clock, you are ready to set or change the alarm. This will not harm your clock in any way, as it is just plastic and can be removed without damaging the inner workings. Undo them, then remove that section of the clock. Inside, there will be more screws on the back. Once you have successfully removed them all, carefully lift off the back panel. Next, take out the screwdriver and undo the screws holding down the back panel of the clock. To set your alarm, you must first open up the clock.
#WESTCLOX ALARM CLOCK HOW TO#
Step by Step Guide: How to Set Westclox Alarm Clock Step One: Opening the Clock To set your Westclox alarm clock, you will need: Once both hands are lined up correctly, you can make adjustments using the side buttons on top of the product, which will move one hour or a minute at a time. You can then use this as a guide when setting your time and date by moving either hand around these sections until they align with what you want them to represent. The dial is divided into 24 hours and 12 hours, with numbers 1-12 representing 12 hours each. To set your Westclox alarm clock, turn it upside down and locate the dial at the bottom of the faceplate. This blog post will provide you with instructions on how to set westclox alarm clock for optimal results. Westclox alarm clocks are a great way to wake up in the morning.
0 kommentar(er)
